Easy tubular cubic right angle weave beaded necklace or bracelet

Tubular necklace

Usually made with the classic cubic right angle weave(CRAW) technique. I made this one by first doing two needles RAW (matting), then just close it up to form the tubular shape.



Materials
1. Any size and shape bead (BB). I used 6mm pearls
2. Size 11/o seed beads(SB)
3. 2 beading needles(optional)
4.  0.25mm 0r 0.3mm beading thread or smaller size if using smaller sized BB
5. Clasp
6. Jumprings

Procedure
1. Cut  a comfortable length beading thread and thread both ends unto a needle (if using needles)
2. Pick 3 BBs and slide down to the middle of the thread.

3. Pick one BB and cross both needles through this bead. Hold the two needles together and pull

4. Pick 1 BB with each needle

5. Pick 1BB and cross both needles through it.

Repeat steps 4 and 5 till 1 unit before desired length


6. For the last unit, pick 3BB with left needle and cross the other needle through the 3rd BB.

7.  Repeat step6

8. Pass the left needle through the adjacent BB from the 1st layer.

9.  Pick 2BBs with the right needle and cross the right needle through the 2nd BB. Pull

 


Repeat steps 8 and 9 till 1 unit to the end

10. Pick 2 BBs with the right needle and cross the left through the 2nd BB.

The threads should come out at the side

11. Pick 3BBs with the right needle and cross the left through the 3rd BB.

Repeat step 7 and 8 till the end. 

12. Pass the one of the threads through the bead path as shown in red.

13. Pick 1 bead and cross both threads through it. Pull

14. Pass each needle through the adjacent side bead.

15. Repeat step 13 i.e pick 1 bead and cross both threads through it.

Repeat steps 14 and 15 till the end

\

We love to get your feedbacks, questions and comments below:)

You can watch the video and adding the loop here

Happy beading :)